OpenStack via DevStack: Difference between revisions
From Xen
Jump to navigationJump to search
Rcpavlicek (talk | contribs) |
Rcpavlicek (talk | contribs) (→Video) |
||
| Line 37: | Line 37: | ||
== Video == |
== Video == |
||
* A [http://xenproject.org/component/allvideoshare/video/latest/xen-project-4-4-installed-in-openstack-devstack-in-under-15-minutes.html video demo] of this process |
* A [http://xenproject.org/component/allvideoshare/video/latest/xen-project-4-4-installed-in-openstack-devstack-in-under-15-minutes.html 15 minute video demo] of this process |
||
== Reference == |
== Reference == |
||
Revision as of 23:05, 14 April 2015
This page is describing how to quickly deploy an OpenStack by using the development tool DevStack on a single machine. Xen Project via libvirt is going to be used.
This how-to describes the steps took on an Ubuntu 14.04 LTS. Little changes should be required to do the same on the other distribution supported by devstack.
How to
We are going to install the Xen Project Hypervisor then setup devstack.
- Install the Xen Project software:
sudo apt-get install xen-hypervisor-4.4-amd64 sudo reboot
- Get devstack:
git clone https://git.openstack.org/openstack-dev/devstack
- Configure devstack:
Edit local.conf in the devstack working repository. (For more options, take a look at DevStack Configuration.)
[[local|localrc]] ADMIN_PASSWORD=secrete DATABASE_PASSWORD=$ADMIN_PASSWORD RABBIT_PASSWORD=$ADMIN_PASSWORD SERVICE_PASSWORD=$ADMIN_PASSWORD SERVICE_TOKEN=a682f596-76f3-11e3-b3b2-e716f9080d50 # Useful logging options for debugging: DEST=/opt/stack LOGFILE=$DEST/logs/stack.sh.log SCREEN_LOGDIR=$DEST/logs/screen # This is a Xen Project host: LIBVIRT_TYPE=xen
- Run devstack:
This might take a while.
./stack.sh
- That's it! You are done!
Video
- A 15 minute video demo of this process
