Difference between revisions of "OpenStack via DevStack"

From Xen
m (How to)
m (Reference)
Line 38: Line 38:
 
== Reference ==
 
== Reference ==
 
* [http://docs.openstack.org/developer/devstack/ DevStack - an OpenStack Community Production]
 
* [http://docs.openstack.org/developer/devstack/ DevStack - an OpenStack Community Production]
* Xen Project patches: (these have been accepted into OpenStack as of February of 2015)
+
* Xen Project patches: (these have been accepted into OpenStack as of February of 2015, so they should not be needed in more current versions)
 
** https://review.openstack.org/146621
 
** https://review.openstack.org/146621
 
** https://review.openstack.org/146622
 
** https://review.openstack.org/146622

Revision as of 22:07, 7 February 2015

This page is describing how to quickly deploy an OpenStack by using the development tool DevStack on a single machine. Xen Project via libvirt is going to be used.

This how-to describes the steps took on an Ubuntu 14.04 LTS. Little changes should be required to do the same on the other distribution supported by devstack.

How to

We are going to install the Xen Project Hypervisor then setup devstack.

  • Install the Xen Project software:
sudo apt-get install xen-hypervisor-4.4-amd64
sudo reboot
  • Get devstack:
git clone https://git.openstack.org/openstack-dev/devstack
  • Configure devstack:

Edit local.conf in the devstack working repository. (For more options, take a look at DevStack Configuration.)

[[local|localrc]]
ADMIN_PASSWORD=secrete
DATABASE_PASSWORD=$ADMIN_PASSWORD
RABBIT_PASSWORD=$ADMIN_PASSWORD
SERVICE_PASSWORD=$ADMIN_PASSWORD
SERVICE_TOKEN=a682f596-76f3-11e3-b3b2-e716f9080d50

# Useful logging options for debugging:
DEST=/opt/stack
LOGFILE=$DEST/logs/stack.sh.log
SCREEN_LOGDIR=$DEST/logs/screen

# This is a Xen Project host:
LIBVIRT_TYPE=xen
  • Run devstack:

This might take a while.

./stack.sh
  • That's it! You are done!

Reference